Olympia A 235 Manuel d'instructions télécharger pdf (Page 19)

Cold Laminating

1 Connect the power cable to an easily accessible, standard electrical

socket.

Caution: Check that the voltage specifications of the unit correspond

to that of your power supply network (220 - 240 V, 50 Hz).

2 Switch on the On/Off switch on the top, right-hand side of the

unit (I).

3 The drive motor for the transport rollers starts up, the red and green

indicator lamps (POWER and READY, respectively) light up.

Caution: If the laminator was switched to hot laminating shortly before,

allow it to cool down. The equipment takes about 30 minutes to cool down.

4 Remove the protective foil from the pouch.

5 Insert the document to be laminated in the pouch so that there is a

margin of approx. 3 - 5 mm to the edge of the foil on all sides.

6 Insert the foil containing the document in the laminator's insertion slot.

Insert the ready closed side of the foil first.

Note: To prevent the laminating foil from creasing, never insert the

open end of the pouch in the insertion slot of the laminator first. When insert-

ing the foil, observe the instructions on the insertion slot. The laminating

process occurs automatically.

Clearing Foil Jams

The laminator is provided with a "Jam Release" function in order to clear foil

jams quickly.

1 If the foil jams, switch the equipment off and use the switch (ABS) on

the right side of the unit.

2 Hold the laminator firmly and pull the foil together with the document to

be laminated out of the laminator's insertion slot.

3 It will probably be necessary to then clean the unit several times as

described in the Section "Cleaning and Servicing".

4 If foil jams occur repeatedly or jammed foil cannot be removed from

the laminator, please contact our hotline.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 65 66

Pas de commentaire

Olympia A 235 Manuel d'instructions Page 19